show
Use the "show" command to display the network interface board configuration settings.
View settings
msh> show
• If "-p" is added, you can view settings one by one.
• For details about the information displayed, see "Understanding the Displayed Information".
• p.85 "Understanding the Displayed Information"
slp
Use the "slp" command to view and configure the SLP settings.
msh> slp ttl "ttl_val"
• You can search the NetWare server using SLP in the PureIP environment of NetWare 5/5.1 and
Netware 6/6.5. Using the "slp" command, you can configure the value of TTL which can be used by
SLP multicast packet.
• The default value of TTL is 1. A search is executed only within a local segment. If the router does not
support multicast, the settings are not available even if the TTL value is increased.
• The acceptable TTL value is between 1 and 255.
• This command is available only when the NetWare is installed.
smb
Use the "smb" command to configure or delete a computer or workgroup name for SMB.
Computer Name settings
msh> smb comp "computer name"
• Set computer name using up to 15 characters. Names beginning with "RNP" or "rnp" cannot be
entered.
Working Group Name settings
msh> smb group "work group name"
• Set workgroup name using up to 15 characters.
Comment settings
msh> smb comment "comment"
2. Remote Maintenance Using telnet
64
To Next Page
Loading...
Need help?
General