Using the Installation Shell Script
The installation shell script helps with the setup process. The installation shell script automates some of the
tasks
in configuring/etc/hosts, /etc/printcap; creating the spool directory for BSD UNIX; and running the
lpadmin command for System V UNIX.
• The installation shell script can be used on the following workstations: (it cannot be used with other
types of workstations.)
•
SunOS 4.x.x
• Solaris 2.x(Sun OS 5.x), Solaris 7, Solaris 8
• HP-UX
• Red Hat Linux
• UnixWare
• OpenServer
• Depending on security settings when installed, rsh/rcp/telnet may not be usable with Red Hat 7.1
or later. Change the security level to allow use of rsh/rcp/telnet. For details about how to change
the setting, see the operating instructions for Red Hat.
•
When you use NIS (Network Information Service) or DNS, you should configure the server before
running the installation shell script.
• Installation shell script does not support CUPS.
• When you use Solaris and HP-UX, you can set UNIX configuration with admintools that came with
Solaris and HP-UX. For details about setting using the admintools, see the admintool's manual.
• For details about the configuration utility of your operating system, see the manual that came with the
utility.
Assigning the IP Address
• Configure the printer to use TCP/IP.
• Make sure that TCP/IP on the printer is set to active. (Default setting is active.)
• Assign an IP address to the printer and configure the other settings required for TCP/IP.
• For details about how to make the above settings, see the manual that comes with this printer.
Using the Installation Shell Script
7
To Next Page
Loading...
Need help?
General