Paper type setting using the
control panel
The [Menu] key > [Paper Input] > [Paper Type: (tray name)] > [Thin
Paper] > the [OK] key
Paper type setting using the
printer driver
[Thin (52 to 59 g/m2)]
Supported input tray Any input tray can be used.
Duplex printing Not supported
Letterhead
Paper type setting using the
control panel
The [Menu] key > [Paper Input] > [Paper Type: (tray name)] >
[Letterhead] > the [OK] key
Paper type setting using the
printer driver
[Letterhead]
Supported input tray Any input tray can be used.
Maintenance
Default: [Letterhead 1]
•
[Letterhead 1]
• [Letterhead 2]
• [Letterhead 3]
If prints made using the paper tray show heavy smudging, use the
following procedure to change the paper type setting from the control
panel:
• Press the [Menu] key, select [Maintenance], [General Settings],
and then select [Letterhead Setting]. Select the paper tray, and
then select [Letterhead 1], [Letterhead 2], or [Letterhead 3].
When specifying paper thickness, remember that a higher number
indicates greater thickness. Also, because the paper thickness will
normally be detected automatically, change this setting only if a print
problem occurs.
Duplex printing Supported
Supported Paper Types
107
To Next Page
Loading...
