Reset setting values
msh> ipsec ike {1|2|3|4|default|all} clear
• Enter the separate setting number [1-4] or [default] and reset the specified setting. Specifying
[all] resets all of the settings, including default.
Initialize Ipsec settings
msh> ipsec clear_init
• Use this command to reset the IPsec settings to their default values. Note however that the IPsec
mode settings will be retained.
Deactivating IPsec Using the Control Panel
To specify this setting, you must log in as a network administrator. For details about how to log in and out
with administrator authentication, see p.25 "Logging in Using Administrator Authentication" and p.25
"Logging out Using Administrator Authentication".
Use the following procedure to deactivate IPsec on this printer.
1. Press the [Menu] key.
2. Press the [ ] or [ ] key to select [Host Interface], and then press the [OK] key.
3. Press the [ ] or [ ] key to select [Network], and then press the [OK] key.
4. Press the [ ] or [ ] key to select [IPsec], and then press the [OK] key.
5. Press the [ ] or [ ] key to select [Inactive], and then press the [OK] key.
6. Press the [Menu] key.
7. Enhanced Network Security
126
To Next Page
Loading...
