For details, see the printer driver Help.
• The data is so large or complex that it takes time to process it. If the data in indicator is blinking, the
data is being processed. Just wait until it resumes.
• If "Waiting for print data..." appears on the display, the printer is now warming up. Wait for a while.
Attached options are not detected in the printer properties.
• The computer and printer are not in two-way communication. You must configure attached options in
the printer properties.
For details, see the printer driver Help.
If the problem cannot be solved, contact your sales or service representative.
When doing aggregate prints or bound prints.
• Check that the paper size and direction set in the printer driver are the same as those set in the
application.
If the settings are not the same, change the settings of the printer driver.
An empty tray is selected by Auto Tray Select, and the document does not print out due to out
of paper error.
• If a paper tray is opened and closed while the printer is in Energy Saver mode, the printer will initialize
the tray upon recovery, but the tray will not be selectable by Auto Tray Select.
To print from a paper tray that you have opened and closed while the printer was in Energy Saver
mode, you must manually specify the tray as the source paper tray before printing. When the printer
recovers from Energy Saver mode and completes initialization, it will then print the document from
the tray you have specified.
Other Printing Problems
187
To Next Page
Loading...
Need help?
General