4. Press the [ ] or [ ] key to select [Level 0], [Level 1], or [Level 2], and then press the [OK]
key.
5. Press the [Menu] key.
Specifying Network Security Level using Web Image Monitor
This can be specified by the network administrator.
Use the following procedure to specify the Network Level setting from Web Image Monitor.
For details about logging in and out with administrator authentication, see p.22 "Using Web Image
Monitor to Configure Administrator Authentication".
1. Log in to Web Image Monitor as an administrator.
2. Click [Configuration] in the Menu area, and then click [Network Security] under "Security"
category.
3. Select the network security level in "Security Level".
4. Click [OK].
5. Click [OK].
6. Click [Logout].
7. Close Web Image Monitor.
Status of functions under each Network Security Level
The following tables show the effects the different network security levels have on each function.
TCP/IP
*1
Function Level 0 Level 1 Level 2
TCP/IP
*2
Active Active Active
HTTP> Port 80 Open Open Open
IPP> Port 80 Open Open Open
IPP> Port 631 Open Open Close
SSL> Port 443 Open Open Open
SSL> Permit SSL/TLS Communication Ciphertext
Priority
Ciphertext
Priority
Ciphertext Only
SSL/TLS version> SSL2.0
*2
Active Active Active
Preventing Unauthorized Access
89
To Next Page
Loading...
Need help?
General