Display current settings
msh> ipsec manual_mode
• Displays the current encryption key manual settings.
Specify encryption key manual settings
msh> ipsec manual_mode {on|off}
• To enable encryption key manual settings, set to [on]. To disable settings, set to [off].
ipsec exclude
To display or specify protocols excluded by IPsec, use the "ipsec exclude" command.
Display current settings
msh> ipsec exclude
• Displays the protocols currently excluded from IPsec transmission.
Specify protocols to exclude
msh> ipsec exclude {https|dns|dhcp|wins|all} {on|off}
• Specify the protocol, and then enter [on] to exclude it, or [off] to include it for IPsec transmission.
Entering [all] specifies all protocols collectively.
ipsec manual
To display or specify the encryption key manual settings, use the "ipsec manual" command.
Display current settings
msh> ipsec manual {1|2|3|4|default}
• To display the settings 1-4, specify the number [1-4].
• To display the default setting, specify [default].
• Not specifying any value displays all of the settings.
Disable settings
msh> ipsec manual {1|2|3|4|default} disable
• To disable the settings 1-4, specify the setting number [1-4].
• To disable the default settings, specify [default].
Specify the local/remote address for settings 1-4
msh> ipsec manual {1|2|3|4} {ipv4|ipv6} local address remote address
• Enter the separate setting number [1-4] or [default] and specify the local address and remote
address.
7. Enhanced Network Security
120
To Next Page
Loading...
Need help?
General