This setting lets you specify [Complexity Setting] and [Minimum Character No.] for the password. By
making this setting, you can limit the available passwords to only those that meet the conditions
specified in [Complexity Setting] and [Minimum Character No.].
If you select [Level 1], specify the password using a combination of two types of characters selected
from upper-case letters, lower-case letters, decimal numbers, and symbols such as #.
If you select [Level 2], specify the password using a combination of three types of characters selected
from upper-case letters, lower-case letters, decimal numbers, and symbols such as #.
Default : [Do not Restrict]
Default : [0]
• Complexity Setting
Level 2
Level 1
Do not Restrict
• Minimum Character No. (0-32)
@Remote Service
This can be specified by the machine administrator.
Communication via HTTPS for [@Remote Service] is disabled if you select [Prohibit].
Default : [Do not Prohibit]
• Prohibit
• Do not Prohibit
Update Firmware
This can be specified by the machine administrator.
Specify whether to allow firmware updates on the printer. Firmware update means having the service
representative update the firmware or updating the firmware via the using FTP, Web Image
Monitor, or the control panel.
If you select [Do not Prohibit], there are no restrictions on firmware updates.
Default : [Do not Prohibit]
• Prohibit
• Do not Prohibit
Change Firmware Structure
This can be specified by the machine administrator.
Specify whether to prevent changes in the firmware structure. The Change Firmware Structure function
detects updating, adding or deleting firmware using the SD card, FTP, Web Image Monitor or the
control panel, or inserting or removing the SD card, or an SD card for a different printer model has
been inserted.
8. Specifying the Extended Security Functions
132
To Next Page
Loading...
