1. SunOS 4.x.x
2. Solaris 2.x, Solaris 7-9 (SunOS5.x)
3. HP-UX
4. UnixWare
5. Linux
6. OpenServer
7. Quit
Enter <1-7>:
If you select "7", the installation shell script ends.
4. Enter the printer's IP address.
Enter Printer host IP address <xxx.xxx.xxx.xxx> [return=skip]:
192.168.15.16
If the host name of the printer has already been configured, press the [RETURN] ([ENTER]) key.
Nothing will be added to the /etc/hosts file.
5. Enter the printer's host name.
Enter Printer host name : nphost
If no IP address was entered in step 4, nothing is added to the /etc/hosts file.
6. Configure the printer name.
Enter logical printer name [default nphost_prn]
If you want to use the default name, press the [RETURN] ([ENTER]) key. Enter a new name, if you
want to use a different one.
The host name entered in step 5 followed by "_prn" appears in "default".
7. Set the print option.
Enter remote printer name [default lp]:
• Press the [RETURN] ([ENTER]) key, and printing with PostScript is enabled.
• If you want to set the device option, enter the option parameter.
Enter remote printer name [default lp]:tray=tray1
• If you enter "text", text printing is enabled.
• If you enter "text", printing with PostScript is disabled.
Enter remote printer name [default lp]:text
You can enter up to 14 characters for HP-UX 11.0, 256 for Solaris 8 and Red Hat Linux 7.0, and 51
for Red Hat Linux 6.2.
After setup with the installation shell script is complete, and if you entered the IP address in step 4, the
following message appears:
Using the Installation Shell Script
9
To Next Page
Loading...
Need help?
General