<interface name> interface down
The interface managed by the supplicant is disabled, or cannot connect to the access point.
<interface name> interface up
The interface managed by the supplicant is enabled, or is connected to the access point.
<Interface> started with IP : <IP address>
IP address (IPv4 or IPv6 address) has been set for the interface and is operating.
<Interface>: Subnet overlap.
The same IP address (IPv4, or IPv6 address) and the subnet mask is used with other device.
IPP cancel-job: permission denied.
User name authentication failed when the spooled job was being canceled.
IPP job canceled. jobid=%d.
The spooled job was canceled due to error or user request.
job canceled. jobid=<job ID>.
The spooled job was canceled due to error or user request.
LeaseTime=<lease time>(sec), RenewTime=<renew time>(sec).
The resource lease time received from the DHCP server is displayed in [lease time] in seconds. The renewal
time is displayed in [renew time] in seconds.
LEAP challenge to access point failed
The LEAP challenge to the access point has failed.
Login to fileserver <file server name> (<IPX|IP>,<NDS|BINDERY>)
When the print server was online, the system logged in to <file server> in NDS or BINDERY mode. The
transfer protocol in use is also displayed.
Manual[%s] is disable, set authentication key.
The specified manual SA entry is invalid. Set the authentication key.
Manual[%s] is disable, set encryption key.
The specified manual SA entry is invalid. Set the authentication key.
Memory allocate error.
Data cannot be obtained.
Disconnect the USB cable, and then connect it.
2. Remote Maintenance Using telnet
102
To Next Page
Loading...
