Using SP Modes
D096 5-16 SM
side, and insert it into the card slot.
4. Turn on the main switch.
5. Start the SP mode and select SP 5824 1.
6. The machine erases the settings on the card (if any), then writes the machine’s
settings to the flash memory card. This takes about 20 seconds. If uploading fails, an
error message appears. If an error message appears, retry the upload procedure.
7. Turn off the main switch.
8. Remove the memory card.
- NVRAM Download (SP 5825 1) -
SP 5825 1 copies the data from the flash memory card to the NVRAM. The following data is
NOT copied (the data in the NVRAM remains unchanged).
SP 8221 1 (ADF Original Feed [Front])
SP 8381 1 (Total: Total Printer Pages)
SP 8382 1 (Copy Application: Total Print Pages)
SP 8391 1 (Large Size Print Pages [A3/DLT, Larger])
1. Turn off the main switch.
2. Remove the card cover [B] (1 rivet).
3. Turn the face of the flash memory card [A] ("A" is printed on it) toward your left-hand
side, and insert it into the card slot.
4. Turn on the main switch.
5. Start the SP mode and select SP 5825 1.
6. The machine erases the current settings, then writes the new settings onto the
NVRAM on the BICU board. This takes about 1 second. If downloading fails, an error
message appears. If an error message appears, retry the download procedure.
7. Turn off the main switch.
8. Remove the memory card.
To Next Page
Loading...
