Ricoh D096 - 3.1.2 SC CODE DESCRIPTIONS

Service Call Conditions
D096 3-2 SM Appendix
3.1.2 SC CODE DESCRIPTIONS
No.
Definition
Symptom Possible Cause
101 B
Exposure Lamp Error
The standard white level
was not detected properly
when scanning the white
plate.
Exposure lamp defective
Exposure lamp stabilizer defective
Exposure lamp connector defective
Dirty scanner mirror or scanner mirror
out of position
SBU board defective
SBU connector defective
Lens block out of position
Incorrect position or width of white
plate scanning (SP4015)
120 B
Scanner home position error 1
The scanner home position
sensor does not detect the
off condition during
initialization or copying.
Scanner home position sensor
defective
Scanner drive motor defective
Scanner home position sensor
connector defective
Scanner drive motor connector
defective
BICU board defective