FREE RUN
B813 14 SM
2.9 FREE RUN
You can use DIP switch 100 (on the DF control board) to carry out a one-sided free
run.
Mode\Bits Bit0 Bit1 Bit2 Bit3
Normal Off Off Off Off
FR with paper On Off Off Off
Feed/Transport Motor Test On On Off Off
Feed Solenoid Test Off Off On Off
Feed Clutch Test On Off On Off
Stamp Solenoid Test Off On On Off
Special I/F Test Off Off Off On
FR without paper On Off Off On
Transport Motor Test On On Off On
FR: Free run
Procedure
1. Set bit 1 and/or bit 2 on SW100 (on the DF control board) to ON.
2. Set originals on the original table.
3. The free run starts automatically after about 2 seconds.
4. To stop the run, set SW100 bits 1 and 2 back to OFF. To ensure that the
system correctly resets, turn power off and then back on.
Free Run Process
1. Set originals on the DF table.
2. The first original sheet feeds into the DF.
3. The sensor detects the original.
4. The DF outputs the original to the exit tray.
5. Steps 2 through 4 repeat for each subsequent original sheet. When all
originals have been fed, the DF stops and waits for more.
To Next Page
Loading...
Need help?
General
