PCU Section
SM 4-29 D096
Replacement
and
Adjustment
4.6.4 OPC DRUM
1. PCU ( p.4-26)
2. Front side piece [A] (
x 1)
3. Rear side piece [B] (
x 2, 1 coupling)
4. Separate the drum section [C] from the developer section [D].
To ensure that the left-side gears line up, keep the drum cover [E] closed
when reinserting the front side piece.
5. Pry out the drum retaining clip [F].
Install the clip in the same orientation (with the lip facing away from the drum
shaft) when you reassemble.
6. OPC drum [G]
7. When reassembling, adjust the image quality (
p.4-33 "After Replacement or
Adjustment").
To Next Page
Loading...
Need help?
General
