Ricoh D096 - DOCUMENT FEEDER DF2000 OVERALL INFORMATION

SM i B813
DOCUMENT FEEDER DF2000 B813
TABLE OF CONTENTS
1. OVERALL INFORMATION ..............................................................1
1.1 MECHANICAL COMPONENT LAYOUT........................................................1
1.2 ELECTRICAL COMPONENT LAYOUT.........................................................2
1.3 DRIVE LAYOUT ............................................................................................3
2. DETAILED SECTION DESCRIPTIONS...........................................4
2.1 ADF B813 AND ARDF B814 .........................................................................4
2.2 ORIGINAL SIZE DETECTION.......................................................................5
2.3 PICK-UP AND SEPARATION .......................................................................7
2.4 ORIGINAL TRANSPORT AND EXIT MECHANISM......................................8
2.5 STAMP ..........................................................................................................9
2.6 TIMING CHARTS ........................................................................................10
2.6.1 A3, STAMP MODE.............................................................................11
2.7 JAM DETECTION........................................................................................12
2.8 OVERALL ELECTRICAL CIRCUIT .............................................................13
2.9 FREE RUN ..................................................................................................14
3. REPLACEMENT AND ADJUSTMENT ..........................................15
3.1 EXTERIOR COVERS ..................................................................................15
3.1.1 REAR COVER....................................................................................15
3.1.2 ORIGINAL TABLE..............................................................................15
3.1.3 FRONT COVER .................................................................................15
3.1.4 ORIGINAL ENTRANCE GUIDE .........................................................15
3.1.5 DF FEED COVER ..............................................................................16
3.2 FEED UNIT..................................................................................................16
3.3 SEPARATION ROLLER ..............................................................................16
3.4 PICK-UP ROLLER.......................................................................................17
3.5 FEED BELT.................................................................................................17
3.6 ORIGINAL SENSORS (WIDTH, LENGTH, TRAILING EDGE)....................18
3.7 ORIGINAL SET SENSOR ...........................................................................19
3.8 TRANSPORT MOTOR ................................................................................19
3.9 FEED COVER OPEN SENSOR/ FEED CLUTCH/ROM/DF DRIVE BOARD20
3.10 REGISTRATION SENSOR....................................................................21
3.11 PICK-UP SOLENOID.............................................................................21
3.12 STAMP SOLENOID...............................................................................22