EasyManuals Logo

Rigol DHO1000 Series User Manual

Rigol DHO1000 Series
261 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #117 background imageLoading...
Page #117 background image
the value. For details, refer to descriptions in
Trigger Level
. The current trigger
level is displayed in the trigger information label at the top of the screen.
8.7.15 SPI Trigger
In SPI trigger, after the CS or timeout condition is satisfied, the oscilloscope triggers
when the specified data is found. When using SPI trigger, y
ou need to specify the CLK
clock sources and MISO data sources.
The figure below shows the sequential chart of SPI bus.
SDA
SCL
CS
D7
D6 D5
D4 D3
D2 D1 D0
Figure 8.30 Sequential Chart of SPI Bus
Tr
igger Type
Click or tap the drop-down button of
Type to select "SPI".
Figure 8.31 SPI Trigger Setting Menu
After a trigger type is selected, the current trigger setting information (including
trigger type, trigger source, and trigger level) is displayed in the trigger information
label at the top of the screen, as shown in the figure below. The information will
change based on the trigger settings.
Triggering the Oscilloscope
DHO1000 User Guide
106
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
www.calcert.com sales@calcert.com1.888.610.7664
0
5
10
15
20
25
30

Table of Contents

Other manuals for Rigol DHO1000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rigol DHO1000 Series and is the answer not in the manual?

Rigol DHO1000 Series Specifications

General IconGeneral
BrandRigol
ModelDHO1000 Series
CategoryTest Equipment
LanguageEnglish

Related product manuals