Rigol DHO1000 Series User Manual

there's something wrong with the keys. Click or tap Exit at the lower
-left corner of the
interface or press
for three consecutive times to exit the key test interface.
Touch T
est
Click or tap
Touch Test to ent
er the touch screen test interface, as shown in the figure
below.
Figure 20.4 Touch Screen Test Interface
Slide with your finger on the scr
een. If there is a line displaying at the empty area
where you slide on the screen and the box that you tap turns out to be filled with
green background, it indicates that the touch function of this area is normal. Click or
tap
Exit at the lower-left corner of the interface or press for three consecutive
times to exit the t
ouch screen test interface.
Screen Test
Click or tap
Screen Test t
o ent
er the screen test interface and check whether the
defective pixel exists.
There are 15 screen test interfaces. Click or tap the screen to switch to the next screen
test interface. Press
for three consecutive times to exit the screen test interface.
Bo
ar
d Test
Click or tap
Board Test, then the bo
ar
d test interface is displayed. Check whether the
status of each module is in good condition.
System Utility Function Setting
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
DHO1000 User Guide
237
www.calcert.com sales@calcert.com1.888.610.7664
0
5
10
15
20
25
30

Rigol DHO1000 Series Specifications

General

Brand	Rigol
Model	DHO1000 Series
Category	Test Equipment
Language	English