Rigol DHO1000 Series User Manual

There is no other warranty, expressed or implied, except such as is expressly set forth
herein or other applicable warranty car
d. There is no implied warranty of
merchantability or fitness for a particular purpose. Under no circumstances shall
RIGOL be liable for any consequential, indirect, ensuing, or special damages for any
breach of warranty in any case.
23.3 Appendix C: Factory Settings
Click or tap the Default button on the t
oolbar at the top of the screen or press the
front-panel
key, then a prompt message "Restore default settings?" is
displayed. Click or tap OK to restore the instrument to its factory default settings, as
shown in the table below
.
Table 23.2 Factory Settings
Parameter Factory Settings
Horizontal
Horizontal Scale 2 μs
Horizontal Position 0 s
Delayed Sweep OFF
Roll Auto
Fine OFF
Horizontal Expansion Center
Acquisition
Acquisition Mode Normal
Memory Depth 10 kpts
Vertical
CH1 ON
CH2 OFF
CH3 OFF
CH4 OFF
Fine OFF
Vertical Scale 50 mV
Vertical Offset 0 V
Channel Unit [V]
Channel Coupling DC
Bias 0 V
BW Limit OFF
Channel Delay 0 s
Display Label OFF
Appendix
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
DHO1000 User Guide
245
www.calcert.com sales@calcert.com1.888.610.7664
0
5
10
15
20
25
30

Rigol DHO1000 Series Specifications

General

Brand	Rigol
Model	DHO1000 Series
Category	Test Equipment
Language	English