Figure 14.16 LIN Decoding Menu
Bus Status
Click or tap the Bus Status on/off swit
ch to enable or disable the bus decoding.
Quickly Apply Trigger Settings to Decoding
Copy trig indicates applying the trigger settings to the specified decoding setting.
Click or tap
Copy Trig to apply the trigger settings t
o the specified decoding setting.
14.6.1 Signal Configuration
Set the source and the threshold
• Click or tap drop-down butt
on of
Source to select the desired source. The
sour
ces include CH1-CH4.
• Click or tap the input field of
Threshold, and then use the pop-up numeric
keyp
ad to set the threshold of the source channel. You can also use the
corresponding multipurpose knob to set the value.
When you modify the threshold of the signal source, a dotted line displaying the
current threshold level is displayed on the screen. It disappears in about 2 s after
you stop modifying the threshold.
Set the Signal
• Click or tap the drop-down button of
Baud Rate to select the b
aud rate. The
available baud rates include 2.4 kbps, 4.8 kbps, 9.6 kbps, 10.0 kbps, 19.2 kbps,
and etc. You can also self-define the baud rate.
• In
Parity bit, click or tap "With" or "Without" to select whether the data
contain the p
arity bit.
Protocol Decoding
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
DHO1000 User Guide
195
www.calcert.com sales@calcert.com1.888.610.7664
0
5
10
15
20
25
30