4.3.2 Connecting to Power
The power requirements of the oscilloscope are 100-240 V, 50-60 Hz. Please use the
power cor
d provided in the accessories to connect the oscilloscope to the AC power
source, as shown in the figure below.
Figure 4.4 Connecting to Power
WARNING
To av
oid electric shock, ensure that the instrument is correctly grounded.
4.3.3 Turn-on Checkout
After the instrument is connected to the power source, press the power switch at
the low
er
-left corner of the front panel to power on the instrument. During the start-
up process, the instrument performs a series of self-tests. After the self-test, the
splash screen is displayed.
• Restart: Click or tap
> Restart. Then a prompt message "Ar
e you sure to
reboot?" is displayed. Click or tap
OK to restart the instrument.
•
Shutdown:
- Click or tap
> Shutdown. Then a prompt message "Ar
e you sure to
shutdown?" is displayed. Click or tap
OK to shut down the instrument.
- Pr
ess the power switch
and a prompt message "Are you sure to
shutdown?" is display
ed. Click or tap
OK to shut down the instrument.
- Pr
ess
twice to directly shut down the instrument.
Quick Start
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
DHO1000 User Guide
13
www.calcert.com sales@calcert.com1.888.610.7664
0
5
10
15
20
25
30