Rigol DHO1000 Series User Manual

Figure 10.13 Track Measurement (after Horizontal Expansion)
Close the Cur
sor Measur
ement Result Window
When cursor measurement is enabled, you can disable it in the following ways:
• In the
Cursors menu, click or tap the Remove butt
on t
o disable cursor
measurements.
• In the "Result" bar at the right side of the screen, click or tap the "Cursors" label
and then click or tap
Remove in the pop-up window.
• In the "R
esult" bar at the right side of the screen, drag the "Cursors" label to the
right to simply disable cursor measurements.
• Press the front-panel
key to disable cursor measurements.
10.3.3 XY Mode
In the Cursors menu, click or tap XY for the Mode item to enable the XY cursor
measur
ement function. The measurement results are displayed in the "Result" bar at
the right section of the screen.
Measurements
DHO1000 User Guide
158
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
www.calcert.com sales@calcert.com1.888.610.7664
0
5
10
15
20
25
30

Rigol DHO1000 Series Specifications

General

Brand	Rigol
Model	DHO1000 Series
Category	Test Equipment
Language	English