14.1.3 Display-related Settings
In Decode menu, set the following display-relat
ed parameters.
Set the Display Format
Click or tap the drop-down button of
Format to select the display format of the bus
data and ev
ent table. The available options include "Hex", "Dec", "Bin", and "ASCII".
Set the Label Display
Click or tap the
Label on/off swit
ch to enable or disable the label display of the
decoding bus. When enabled, the bus label will be displayed at the upper-left side of
the bus (when the bus display is enabled). The label shows the current bus type.
14.1.4 Event Table
The event table displays the decoded data and the corresponding decoding
information in time or
der in the form of a table. It can be used to observe relatively
longer decoded data. The decoding information includes the decoded data, the
corresponding line number, and time information.
Open or Close the Event Table
Click or tap the
Event Table on/off swit
ch to enable or disable the display of the
event table. When enabled, the event table is displayed as shown in the figure below.
You can also click or tap the icon
at the upper-right corner of the table to close
the event table.
Figure 14.3 Parallel Decoding Event Table
Protocol Decoding
DHO1000 User Guide
178
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
www.calcert.com sales@calcert.com1.888.610.7664
0
5
10
15
20
25
30
To Next Page
Loading...
