RKC INSTRUMENT PF900 User Manual

4. BASIC OPERATION
IMR02L04-E3
4-23
PID memory group
setting block
PV
PID
M:S SV
30000000200
PV
PID.GR
M:S SV
53000000001
PID memory group
number





P: Proportional band [heat-side]
I: Integral time [heat-side]
D: Derivative time [heat-side]
rPT: Control response parameter
Pc: Proportional band [cool-side]
Ic: Integral time [cool-side]
Dc: Derivative time [cool-side]
DB: Overlap/Deadband
YDB: Open/Close output neutral zone
MR: Manual reset
OLH: Output limiter high (MV1)
OLL: Output limiter low (MV1)
OLH2: Output limiter high (MV2)
OLL2: Output limiter low (MV2)
OHH: ON/OFF action differential gap (upper)
OHL: ON/OFF action differential gap (lower)
LBA: Control loop break alarm (LBA) time
LBD: LBA deadband (LBD)
Setting parameters in the PID memory group
Wait memory group
setting block
Program
setting block


PV
PID.GR
M:S SV
53000000000
PID memory group
number
PV
P EV.GR
M:S SV
53000000001
Event memory group
number
PV
L WT.GR
M:S SV
F60.01R00001
Wait memory group
number
PV
SIGNL
M:S SV
RES00000000
Segment signal
(Displays when the Segment
signal is selected.)



Program memory group
setting block
PV
PR.MEM
M:S SV
30000000200
Setting pattern
number
PV
PTN.NO
M:S SV
53000000001



Event memory group
setting block
*
PV
EVENT
M:S SV
30000000200
PV
P EV.GR
M:S SV
53000000001
Event memory group
number





PV
ZOEV1 $
M:S SV
GR.0 1 0-00050
Event 1 set value (EV1)
Event 1 set value (EV1) [high]
PV
Z EV1` $
M:S SV
GR.0 1 0 -0050

Event 1 set value (EV1')
[low]
EV2: Event 2 set value (EV2)
Event 2 set value (EV2) [high]
EV2`: Event 2 set value (EV2') [low]
EV3: Event 3 set value (EV3)
Event 3 set value (EV3) [high]
EV3`: Event 3 set value (EV3') [low]
EV4: Event 4 set value (EV4)
Event 4 set value (EV4) [high]
EV4`: Event 4 set value (EV4') [low]

Go to the setting
display of the
next segment.
A
fter setting parameters
of all segments
* Event memory group setting block does
not display when types of Event 1 to 4
are all set to “0: None.”
Press the STEP R.SET key to go back to the previous display.
Press the STEP R.SET key while pressing the

key to go
back to the first setting display of the setting block.


(P. 4-17)
(P. 4-18)
(P. 4-19)

RKC INSTRUMENT PF900 Specifications

General

Brand	RKC INSTRUMENT
Model	PF900
Category	Controller
Language	English