Rohde & Schwarz EMI Test ReceiverESCI - Page 100

Setting Parameters R&S ESCI
1166.6004.12 3.26 E-1
! Press the ENTER key or the spinwheel.
The parameter/the setting has been selected.
The selected parameter can be edited the way described below:
3. Editing the marked parameter
LIMIT LINES
checkmark
MARGIN
-10 dB
TRACE
1
2
3
NAME COMPATIBLE LIMIT CHECK TRACE MARGIN
GSM22UP off 1 0 dB
LP1GHz on 2 0 dB
LP1GHz off 1 0 dB
MIL461A off 2 -10 dB
a) Toggling between two
states
If an element of a table can be switched on and off only, the
unit keys are used to toggle between these two states.
! Press one of the unit keys.
The table element is switched on and provided with a
checkmark. (√).
! Press one of the unit keys once more.
The table element is switched off.
or
! Press one of the unit keys.
The table element is switched on, "on" is displayed.
! Press one of the unit keys once more.
The table element is switched off, "off" is displayed