Rohde & Schwarz EMI Test ReceiverESCI - Page 189

R&S ESCI Receiver - MKR->
1166.6004.12 4.57 E-2
SELECT
MARKER
The SELECT MARKER softkey activates the numerical selection of the
marker in the data entry field. If no marker is active when MKR-> menu is
called, MARKER 1 is automatically switched on. Delta marker 1 is selected
by input of ' 0 '.
IEC/IEEE-bus command: CALC:MARK1 ON;
CALC:MARK1:X <value>;
CALC:MARK1:Y?
PEAK
The PEAK softkey sets the active marker or delta marker to the peak of the
trace.
If no marker is active when MKR-> menu is called, MARKER 1 is
automatically switched on and the peak search is performed.
IEC/IEEE-bus command: CALC:MARK:MAX
CALC:DELT:MAX
NEXT PEAK
The NEXT PEAK softkey sets the active marker/delta marker to the next
lower peak value on the trace. The search direction is defined in the NEXT
MODE submenu (see analyzer mode).
IEC/IEEE-bus command: CALC:MARK:MAX:NEXT
CALC:DELT:MAX:NEXT
NEXT PEAK
RIGHT
The NEXT PEAK RIGHT softkey sets the active marker/delta marker to the
next lower peak value to the right on the trace.
IEC/IEEE bus commands: CALC:MARK:MAX:RIGH
CALC:DELT:MAX:RIGH
NEXT PEAK
LEFT
The NEXT PEAK LEFT softkey sets the active marker/delta marker to the
next lower peak value to the left on the trace.
d
IEC/IEEE bus commands: CALC:MARK:MAX:LEFT
CALC:DELT:MAX:LEFT
ADD TO
PEAK LIST
The ADD TO PEAK LIST softkey adds the receiver frequency of the current
marker to the peak list (see also Section "Data Reduction and Peak List").
IEC/IEEE bus command --
TUNE TO
MARKER
The TUNE TO MARKER softkey sets the receiver frequency to the marker
frequency.
IEC/IEEE bus command :CALC:MARK:FUNC:CENT
MARKER
TRACK
The MARKER TRACK softkey couples the current receive frequency to the
marker frequency.
IEC/IEEE bus command :CALC:MARK:COUP ON