TRACE softkey sets the active marker to a new trace. Please
note that only a trace visible in the measurement window can be selected.
This softkey is also available in the MKR menu.
IEC/IEEE-bus command: CALC:MARK:TRAC 2
Example:
Three traces are displayed on the screen. The marker is always on Trace 1
after switching on.
[MKR ->TRACE ] "2" <ENTER> The marker jumps to Trace 2 but remains
at the previous frequency or time.
[MKR ->TRACE] "3" <ENTER> The marker jumps to Trace 3.
MKR->
STEPSIZE
The MKR
CF STEPSIZE softkey sets the step size for the receiver
frequency variation to the current marker frequency, and also sets step size
adaptation to MANUAL. STEPSIZE remains at this value until the receiver
frequency entry mode in the STEP menu is switched from MANUAL to AUTO
again.
The MKR
CF STEPSIZE function is, above all, useful in the measurement
of harmonics.
IEC/IEEE-bus command: CALC:MARK:FUNC:CST
MIN
The MIN softkey sets the active marker to the minimum value on the
corresponding trace.
IEC/IEEE-bus command: CALC:MARK:MIN
CALC:DELT:MIN
NEXT MIN
The NEXT MIN softkey sets the active marker to the next higher minimum
value on the corresponding trace. The search direction is defined in the
NEXT MODE submenu (see below).
IEC/IEEE-bus command: CALC:MARK:MIN:NEXT
CALC:DELT:MIN:NEXT
NEXT MIN
LEFT
The NEXT MIN LEFT softkey sets the active marker to the next higher
minimum value to the left on the corresponding trace.
IEC/IEEE-bus command: CALC:MARK:MIN:LEFT
CALC:DELT:MIN:LEFT
NEXT MIN
RIGHT
The NEXT MIN RIGHT softkey sets the active marker to the next higher
minimum value to the right on the corresponding trace.
IEC/IEEE-bus command: CALC:MARK:MIN:RIGH
CALC:DELT:MIN:RIGH
To Next Page
Loading...
