Rohde & Schwarz EMI Test ReceiverESCI - Page 330

Display R&S ESCI
1166.6004.12 4.198 E-1
DEFAULT
CONFIG
The DEFAULT CONFIG softkey activates the preset
settings of the PARAMETER COUPLING table.
IEC/IEEE-bus command: --
ENABLE
ALL ITEMS
The ENABLE ALL ITEMS softkey switches all of the
possible couplings to on. The coupling of center frequency
is switched on, therefore coupling of start /stop frequency is
switched off.
IEC/IEEE-bus command: --
DISABLE
ALL ITEMS
The DISABLE ALL ITEMS softkey switches all of the
possible couplings to off.
IEC/IEEE-bus command: --
BARGRAPH
MAXHOLD
The BARGRAPH MAXHOLD switches on the maxhold display of a single
measurement..