R&S ESCI Display
1166.6004.12 4.197 E-1
SPLIT
SCREEN
The SPLIT SCREEN softkey selects the display of two diagrams. The upper
diagram is designated SCREEN A, the lower diagram SCREEN B.
Switching between SCREEN A and SCREEN B is performed via the
corresponding key in the HOTKEY bar. The active window is marked by
highlighting fields
A
and
B
on the right of the diagram.
In Receiver mode, screen A displays the receiver bargraph and screen B the
scan diagram.
In Mixed mode, two screen combinations are avaiable:
Level and frequency display (screen A) and analyzer spectrum (screen B)
or
Analyzer spectrum (screen B) and scan spectrum (screen B)
IEC/IEEE-bus command: DISP:FORM SPL
PARAM
COUPLING
The PARAM COUPLING softkey opens the submenu for selecting the
coupled parameters of receiver and analyzer mode.
COUPLING
TABLE
The COUPLING TABLE softkey opens the PARAMETER
COUPLING table.
IEC/IEEE-bus commands: --
Analyzer Center INST:COUP:CENT ALL
Start-Stop INST:COUP:SPAN ALL
Attenuation, Unit INST:COUP:ATT ALL
Minimum Attenuation INST:COUP:PROT ALL
Preamp INST:COUP:GAIN ALL
Preselector INST:COUP:PRES ALL
Demodulator INST:COUP:DEM ALL
Bandwidth INST:COUP:BWID ALL
To Next Page
Loading...
