R&S ESCI Display
1166.6004.12 4.201 E-1
DATAENTRY
OPAQUE
The DATAENTRY OPAQUE softkey sets the data entry windows to
opaque. This means that entry windows are underlayed with the
background color for tables.
IEC/IEEE-bus command: --
DEFAULT
COLORS 1
DEFAULT
COLORS 2
The DEFAULT COLORS 1 and 2 softkey restores the default
settings for brightness, color tint and color saturation for all display
screen elements.
The color schemes have been selected to give optimum visibility of
all picture elements at an angle of vision from above or below.
DEFAULT COLORS 1 is active in the default setting of the
instrument.
IEC/IEEE-bus command: DISP:CMAP:DEF1
DISP:CMAP:DEF2
DISPLAY
PWR SAVE
The DISPLAY PWR SAVE softkey is used to switch on/off the
power-save mode for the display and to enter the time for the
power-save fuction to respond. After the elapse of this time the
display is completely switched off, ie including backlighting.
Note: This mode is recommended for saving the TFT display
especially when the instrument is exclusively operated
in remote control.
The power-save mode is configured as follows:
• The first keystroke activates the power-save mode and opens
the editor for the response time (POWER SAVE TIMEOUT).
The response time is entered in minutes between 1 and 6
minutes and is confirmed by ENTER.
• The power-save mode is deactivated by pressing the key again.
On leaving the menu with the power-save mode in the activated
state, the softkey is highlighted in color on returning to the menu
and opens again the editor for the response time. Pressing again
the key switches off the power-save mode.
IEC/IEEE-bus command: DISP:PSAV ON
DISP:PSAV:HOLD 15
SELECT
OBJECT
The SELECT OBJECT softkey activates the SELECT DISPLAY
OBJECT table, with which a graphics element can be selected.
After selection, the brightness, tint and saturation of the selected
element can be changed using the softkeys of the same name. The
color changes by means of the PREDEFINED COLORS softkey
can be seen immediately on the display screen.