Rohde & Schwarz EMI Test ReceiverESCI - Page 336

Configuration/Setup R&S ESCI
1166.6004.12 4.204 E-3
GENERAL
SETUP
REFERENCE
INT EXT
SERVICE
PREAMP
ON OFF
NOISE SRC
ON OFF
SYSTEM
INFO
PRESEL
ON OFF
TRANSDUCER
FACTOR
SETUP
TRANSDUCER
SET
TRANSDUCER
NEW
EDIT
DELETE
VIEW
TRANSDUCER
PAGE
UP
PAGE
DOWN
TRANSDUCER
FACTOR
TRD FACTOR
MAME
DELETE
LINE
TRANSDUCER
SET
INS BEFORE
RANGE
RANGE
1-5 6-10
SAVE TRD
FACTOR
TRD FACTOR
UNIT
TRD FACTOR
VALUES
INSERT
LINE
INS AFTER
RANGE
DELETE
RANGE
SAVE TRD
SET
The following settings can be modified here:
• The REFERENCE INT/EXT softkey determines the source of the reference
• The NOISE SRC ON/OFF softkey switches on and off the voltage supply for an external noise
source.
• The PREAMP softkey switches on the RF preamplifier gain..
• The PRESELECT ON/OFF softkey is used to switch the preselection.
• The TRANSDUCER softkey opens a submenu for editing and creating transducer factors and sets.
• The GENERAL SETUP softkey opens a submenu for all the general settings such as IEC/IEEE-bus
address, date and time as well as the configuration of the device interfaces.
• The SYSTEM INFO softkey opens a submenu for displaying the hardware configuration of the
instrument, the switching cycle statistics and system messages.
• The SERVICE softkey opens a submenu in which special device functions and system information
can be selected for servicing. The password required for service functions can be entered in this
submenu.
• The SERVICE FUNCTIONS softkey enables additional special settings for servicing and
troubleshooting. It is available after entering the corresponding password under the SERVICE
softkey.