Measurement Documentation R&S ESCI
1166.6004.12 4.256 E-1
Notes:
1. With SCREEN and OPTIMIZED selected, the background will always be white and the
grid black. With USER DEFINED, these colours can be selected, too.
2. Upon activation of the submenu, the colour display is switched over to the selected
printout colours. When the menu is quit, the original colour setting is restored.
The COMMENT SCREEN A and COMMENT SCREEN B softkeys allow text to be added to the printout
(date and time are inserted automatically).
Use the INSTALL PRINTER softkey to install additional printer drivers.
PRINT
SCREEN
The PRINT SCREEN softkey starts the output of test results.
All the diagrams, traces, markers, marker lists, limit lines etc are printed out
as long as they are displayed on the screen. All the softkeys, tables and open
data entry fields are not printed out. Moreover, comments, title, date, and
time are output at the bottom margin of the printout .
IEC/IEEE-bus command: HCOP:ITEM:ALL
HCOP:IMM
PRINT
TRACE
The PRINT TRACE softkey starts the output of all curves visible on the
display screen without auxiliary information. Specifically, no markers or
display lines are printed.
IEC/IEEE-bus command: HCOP:ITEM:WIND:TRAC:STAT ON
HCOP:IMM
PRINT
TABLE
The PRINT TABLE softkey starts the output of all tables and info lists visible
on the display screen without the measurement diagrams and other
information lying behind.
IEC/IEEE-bus command: HCOP:ITEM:WIND:TABL:STAT ON
HCOP:IMM
DEVICE
SETUP
The DEVICE SETUP softkey opens the dialog where the file format and the
printer can be selected (see section "Selecting Printer, Clipboard and File
Formats").
IEC/IEEE-bus commands: HCOP:DEV:LANG GDI;
SYST:COMM:PRIN:ENUM:FIRS?;
SYST:COMM:PRIN:ENUM:NEXT?;
SYST:COMM:PRIN:SEL <Printer>;
HCOP:PAGE:ORI PORT;
HCOP:DEST "SYST:COMM:PRIN";
HCOP:DEST "SYST:COMM:MMEM"
DEVICE
1 2
The analyzer is able to manage two hardcopy settings independently of each
other. They are selected via the DEVICE 1 / 2 softkey, which displays also the
associated setting if the DEVICE SETUP dialog is open.
IEC/IEEE-bus command: --
To Next Page
Loading...
