Tracking Generator - Option R&S FSP-B9 R&S ESCI
1166.6004.12 4.278 E-1
REF VALUE
The REF VALUE POSITION softkey marks a reference position in the
active window at which the normalization result (calculated difference with a
reference trace) is displayed.
If no reference line is active, the softkey switches on a reference line and
activates the input of its position. The line can be moved within the grid
boundaries.
The reference line is switched off by pressing the softkey again.
The function of the reference line is explained in the section "Calibration
mechanisms".
Fig. 4-28 Normalized measurement, shifted with REF VALUE
POSITION 50 %
IEC/IEEE-bus command: DISP:WIND:TRAC:Y:RPOS 10PCT
To Next Page
Loading...
