Setting Parameters R&S ESCI
1166.6004.12 3.16 E-1
3. Various softkeys act like selection
switches. Only one softkey may be
active at a time.
Example: sweep setting
! Press SWEEP key.
! Press CONTINUOUS SWEEP softkey.
The continuous sweep is thus set. The CONTINOUS
SWEEP softkey is colored (factory-set: green). The
second alternative, a series of n sweeps according to
the trigger definition, can be selected via the SINGLE
SWEEP softkey in the same menu. Only one of the two
softkeys can be active at a time, the softkeys thus act
like selection switches.
CONTINUOUS
SWEEP
SINGLE
SWEEP
CONTINUOUS
SWEEP
SINGLE
SWEEP
4. The softkey is used to select the
parameter, the setting is made in
an alphanumeric data entry
window.
Example: SWEEP COUNT parameter
! Press SWEEP key
! Press SWEEP COUNT softkey.
The window for entering the number of sweeps for the
SINGLE SWEEP mode is opened. The softkey is
colored (factory-set: red). (Data entry is described in the
next section).
SWEEP
COUNT
SPAN
100
SWEEP COUNT
To Next Page
Loading...
