Network and Remote Control Operation
R&S
®
SGS100A
172User Manual 1173.9105.02 ─ 12
To set up a Telnet connection
To control the software, only a telnet program is required. The telnet program is part of
every operating system.
1. To establish a Telnet connection with the R&S SGS, start the telnet program. Enter
the socket address.
The socket address is a combination of the IP address or the host name of the
R&S SGS and the number of the port configured for remote-control via telnet.
Tip: The R&S SGS uses the port number 5025 for remote connection via Telnet.
The connection to the instrument is set up and remote-control commands can be
sent.
2. Even if the cursor is not visible on the screen, enter blind a remote-control com-
mand and confirm with Enter.
10.3 Advanced Remote Control Using PCIe
The PCIe bus is a high-speed serial bus, composed of point-to-point serial links. A pair
of serial links, one transmitting and one receiving link, make up a lane.
Advanced Remote Control Using PCIe
To Next Page
Loading...