Rohde & Schwarz SGS100A - Test:extension:connection; Test:extension:connection:rf

Remote Control Commands
R&S
®
SGS100A
212User Manual 1173.9105.02 ─ 12
Example: See Chapter 11.1.5, "Enabling and Configuring an Extension
Mode", on page 197.
Usage: Query only
Manual operation: See "Available Instruments" on page 126
:EXTension:SELect <SelNr>
Selects an extension by its index number. The subsequent SCPI commands are rela-
ted to this extension.
Parameters:
<SelNr> float
0
no selection
Example: See Chapter 11.1.5, "Enabling and Configuring an Extension
Mode", on page 197.
:TEST:EXTension:CONNection?
Returns the results of a test to all signal connections between the instrument and the
extension.
Return values:
<State> 0 | 1 | OFF | ON
0: no error detected
1: error detected
Usage: Query only
Manual operation: See "Test Signal Connections" on page 126
:TEST:EXTension:CONNection:RF?
Returns the results of a test of the RF signal connection to the extension. This query
does not report errors to the SCPI error queue.
You can use this SCPI to detect which extension is physically connected to a device.
Return values:
<State> 0 | 1 | OFF | ON
0: no error detected
1: error detected
Usage: Query only
Manual operation: See "Test Signal Connections" on page 126
EXTension Subsystem