Understanding the R&S SGMA-GUI Software
R&S
®
SGS100A
59User Manual 1173.9105.02 ─ 12
Remote command:
:INSTruments:REMote:NAME on page 77
GPIB Address
Enters the GPIB address of the connected instrument.
See also Chapter 10.1.5, "GPIB Interface (IEC/IEEE Bus Interface)", on page 170.
Remote command:
:INSTruments:GPIB:ADDRess on page 78
Board Number
Identifies the GPIB bus card of the controller to that the adapter is connected.
See also Chapter 10.1.5, "GPIB Interface (IEC/IEEE Bus Interface)", on page 170.
Remote command:
:INSTruments:GPIB:BOARd on page 78
Serial Number
Enters the serial number as instrument's identification while using the USB or PCIe
interfaces for remote control.
Remote command:
:INSTruments:SERial on page 78
OK
Confirms the settings and closes the dialog.
Apply
Confirms the settings.
Cancel
Discards settings and closes the dialog.
6.1.2.3 Versions/Options Dialog
Querying information about the installed options and software version
► Select "Setup > Software".
An info dialog opens, showing program information.
Operating Menu and Toolbar
To Next Page
Loading...
