Rohde & Schwarz SGS100A - Keyboard Tests; Self-Test

General Instrument Settings and Instrument Setup
R&S
®
SGS100A
145User Manual 1173.9105.02 ─ 12
8.14.1 Self-test
1. To access this dialog, select "SGMA-GUI > Instrument Name > Diagnostic Tests >
Self-test".
2. To trigger a self-test, select "Self-test".
Performs a self-test on all installed hardware options.
The result of the self-test, succeeded or failed, is displayed. The list of the numeric
results of the performed test cases is protected by protection level 2.
SCPI command:
:TEST:ALL:STARt on page 278
:TEST:ALL:RESult? on page 278
8.14.2 Keyboard Tests
Access:
► Select "SGMA-GUI > Instrument Name > Diagnostic Tests > Keyboard Test".
Use this function to check the proper operation of all front panel elements.
If "Keyboard Test" is enabled, all front panel LEDs except the [POWER ON] are
orange.
The exact test procedure is described in the service manual.
SCPI command:
:TEST:KEYBoard[:STATe] on page 278
Diagnostic and Tests