Rohde & Schwarz SGS100A - 11.17 Source:power Subsystem; Source:power Subsystem; [:Source]:Power:alc:dsensitivity; [:Source]:Power:alc:sonce

Remote Control Commands
R&S
®
SGS100A
249User Manual 1173.9105.02 ─ 12
11.17 SOURce:POWer Subsystem
[:SOURce]:POWer:ALC:DSENsitivity............................................................................... 249
[:SOURce]:POWer:ALC[:STATe]...................................................................................... 249
[:SOURce]:POWer:ALC:SONCe......................................................................................249
[:SOURce]:POWer:ATTenuation:RFOFf:MODE................................................................. 250
[:SOURce]:POWer:ATTenuation:SOVer[:OFFSet]..............................................................250
[:SOURce]:POWer:LMODe............................................................................................. 250
[:SOURce]:POWer:POWer..............................................................................................250
[:SOURce]:POWer:SCHaracteristic..................................................................................251
[:SOURce]:POWer[:LEVel][:IMMediate][:AMPLitude]..........................................................251
[:SOURce]:POWer[:LEVel][:IMMediate]:OFFSet................................................................ 252
[:SOURce]:POWer:LIMit[:AMPLitude]...............................................................................252
[:SOURce]:POWer:PEP?................................................................................................ 252
[:SOURce]:POWer:RANGe:LOWer?................................................................................ 253
[:SOURce]:POWer:RANGe:UPPer?.................................................................................253
[:SOURce]:POWer:ALC:DSENsitivity <Sensitivity>
Sets the power detector sensitivity. Used for compatibility reasons only.
Parameters:
<Sensitivity> OFF | LOW | MED | HIGH
*RST: OFF
Manual operation: See "Detector Sensitivity" on page 93
[:SOURce]:POWer:ALC[:STATe] <State>
Activates/deactivates automatic level control.
Parameters:
<State> 1 | OFFTable | OFF | ONTable | AUTO | ON
*RST: ONTable
Example: See Chapter 11.1.2, "Generating an I/Q Modulated Signal",
on page 193.
Manual operation: See "State" on page 93
[:SOURce]:POWer:ALC:SONCe
Briefly activates level control for correction purposes.
Usage:
Event
Manual operation: See "Readjust" on page 90
SOURce:POWer Subsystem