General Instrument Settings and Instrument Setup
R&S
®
SGS100A
138User Manual 1173.9105.02 ─ 12
Security Password ← Security Settings
Enters the password that is required to enable or to disable the settings protected by a
security password. The default is '123456'.
Note: It is highly recommended to change the default security password before con-
necting the instrument to the network. To change the security password, select
"SGMA-GUI > Instrument Name > Setup > Security > Change Security Password".
The settings are only accepted after the "Accept" button is pressed.
Accept ← Security Settings
Accept a new entry or selection and change the settings accordingly.
8.8 Maintenance
The R&S SGS provides a special dialog for performing some maintenance procedures,
like installing firmware packages.
► To access this dialog, select "SGMA-GUI > Instrument Name > Setup > Mainte-
nance".
Operation
Selects the desired maintenance operation.
Select Package
Available only for "Operation > Install Firmware Package".
Selects the firmware package to be installed, see also Chapter 9.12, "How to Install a
New Firmware Version on the Instrument", on page 159.
Update All
Available only for "Operation > Install Firmware Package".
Enable this function to perform a simultaneous firmware update on all instruments, that
are in active state and are connected to this controller.
Note: A firmware update and the required subsequent restart and the automatically ini-
tiated internal adjustment process of the controller may be a time consuming operation.
Maintenance
To Next Page
Loading...
