Understanding the R&S SGMA-GUI Software
R&S
®
SGS100A
61User Manual 1173.9105.02 ─ 12
Protection Level / Password
"Protection Level 1" can be activated to expand the functionality of the internal adjust-
ment. The password is 123456.
The other protection levels 2 to 4 provide access to protected service functions. Only
the authorized personnel of Rohde & Schwarz service departments can access these
functions.
6.1.2.5 Reset SGMA-GUI
Resets R&S SGMA-GUI to its factory preset settings.
The connected instruments are not affected by this preset.
To preset one specific instrument to its factory preset settings, select "SGMA-GUI >
Instrument Name > Setup > Factory Preset". Refer to Chapter 8.11, "Factory Preset",
on page 142 for an overview of the settings affected by this function.
6.1.2.6 Remote
Access: "SGMA-GUI > Setup > Remote".
SCPI Port
Sets the port number of the LAN interface for remote control with TCP/IP socket proto-
col.
This allows you to set different port numbers if you want to control different software,
e.g. R&S SGMA-GUI and R&S WinIQSIM2, from the same application.
Remote command:
:SYSTem:COMMunicate:SOCKet:PORT on page 273
Operating Menu and Toolbar
To Next Page
Loading...