Rohde & Schwarz SGS100A - Connector Subsystem

Remote Control Commands
R&S
®
SGS100A
208User Manual 1173.9105.02 ─ 12
:CALibration:ROSCillator[:DATA] <Data>
Sets the calibration value for the custom defined external adjustment.
Parameters:
<Data> integer
Range: 0 to INT_MAX
*RST: 0
Example: See :CALibration:ROSCillator:DATA:MODE on page 207
Manual operation: See "Calibration Value" on page 146
11.6
CONNector Subsystem
:CONNector:REFLo:OUTPut...........................................................................................208
:CONNector:TRIGger:OMODe.........................................................................................208
:CONNector:REFLo:OUTPut <Output>
Determines the signal provided at the output connector [REF/LO OUT] (rear of the
instrument).
Parameters:
<Output> REF | LO | OFF
*RST: REF
Manual operation: See "REF/LO Output" on page 84
:CONNector:TRIGger:OMODe <Mode>
Sets the operating mode of the trigger connector.
The parameters PVOut|PETRigger|PEMSource are available only with option
R&S SGS-K22.
Parameters:
<Mode> SVALid | SNValid | PVOut | PETRigger | PEMSource
SVALid|SNValid
signal valid /not valid
PVOut
pulse generator video out
PETRigger
pulse generator external trigger
PEMSource
external pulse modulator source
Manual operation: See "Trigger Connector Mode" on page 116
CONNector Subsystem