Network and Remote Control Operation
R&S
®
SGS100A
183User Manual 1173.9105.02 ─ 12
The following advanced parameters are available:
●
"mDNS and DNS-SD": The additional protocols "multicast DNS" and "DNS service
discovery" are used for device communication in zero configuration networks,
working without DNS and DHCP.
●
"ICMP Ping": Must be enabled to use the ping utility.
If you disable this setting, the instrument does not answer ping requests. The set-
ting does not affect the LXI ping client. You can ping other hosts from the instru-
ment, even if the setting is disabled.
●
"VXI-11 Discovery": Must be enabled to detect the instrument in the LAN.
If you disable this setting, the instrument cannot be detected by the VXI-11 discov-
ery protocol mechanism. The setting does not affect other detection mechanisms.
Setting up a VXI-11 connection via the IP address or the host name is independent
of this setting.
Password protection
Changing the LAN configuration is password-protected and requires the security pass-
word. The default password is "instrument".
10.5.3.3 Ping Client
The "Ping Client" page provides the ping utility to verify the connection between the
LXI-compliant instrument and another device.
The ping is initiated from the instrument. Using the ICMP echo request and echo reply
packets, the function checks whether the communication with a device via LAN is
working. Ping is useful for the diagnosis of IP network or router failures.
LXI Configuration
To Next Page
Loading...