Error Messages and Troubleshooting
R&S
®
SGS100A
289User Manual 1173.9105.02 ─ 12
Error
Code
Error Description Remedy
180 Adjustment failed Adjustment could not be executed The adjustment data have to be
generated first by an internal or
external adjustment or to be loa-
ded into the device.
182 Adjustment data miss-
ing
Adjustment data are missing. The adjustment data have to be
generated first by an internal or
external adjustment or to be loa-
ded into the instrument.
183 Adjustment data inva-
lid
Adjustment data are invalid and must
be restored.
The adjustment data have to be
generated again by an internal or
external adjustment or to be loa-
ded into the instrument.
200 Cannot access hard-
ware
The data transmission to a module
was unsuccessful.
The module is not installed, not
properly installed or missing.
201 Hardware revision out
of date
A later version of certain parts of the
instrument is necessary to execute
the function selected.
The driver does not support the
installed version of a module.
202 Cannot access the
EEPROM
A error occurs when writing or reading
a EEPROM.
The EEPROM might be defect
and has to be replaced.
203 Invalid EEPROM data
204 Driver initialization
failed
Initialization of a driver fails when
booting the instrument firmware.
The driver is not compatible with
the hardware or software config-
uration of the instrument.
241 No current list There is no list selected. To execute the required opera-
tion, a list has to be selected in
the related dialog. If no list is
available, a new list must be cre-
ated.
242 Unknown list type
specified
The list type selected is not valid for
the required operation.
For instance, the file extension for
mapping files is *.map. It is not possi-
ble to enter another file extension
when selecting a list.
Check the selected list type.
460 Cannot open file The selected file can not be opened. Check the path and file name.
461 Cannot write file The file can not be written. Check if the file is read-only.
462 Cannot read file The file can not be read. Check if the file contents are
compatible with the file type.
463 Filename missing The required operation cannot be
executed because the file name is not
specified.
A file name has to be entered
when creating a new list.
464 Invalid filename exten-
sion
The file extension is not valid for the
required operation.
Check the file extension.
For instance, the file extension
for the mapping files is *.map. It
is not possible to enter another
file extension when storing a list.
Device-Specific Error Messages
To Next Page
Loading...