Chapter 4
System Administration
RUGGEDCOM RSG2488
User Guide
98 Viewing and Clearing Latched Alarms
Figure 63: Alarms Table
NOTE
This same list is accessible through the Command Line Interface (CLI) using the alarms. For more
information, refer to Section 2.6.1, “Available CLI Commands”.
For information about modifying a pre-configured alarm, refer toSection 4.4.3, “Configuring an Alarm”.
Section 4.4.2
Viewing and Clearing Latched Alarms
To view a list of alarms that are configured to latch, navigate to Diagnostics > View Latched Alarms. The Latched
Alarms table appears.
Figure 64: Latched Alarms Table
To Next Page
Loading...
