RuggedCom RSG2488 User Manual

RUGGEDCOM RSG2488
User Guide
Chapter 3
Device Management
Configuring the Management IP Interface 71
Only one subnet is assigned to be the management subnet and can be used by management applications, such
as Web Server, SSH, etc.
NOTE
Subnets must be specifically defined for each interface. Subnets must not be a part of another subnet
configured on the device.
The following sections describe how to set up and manage IP interfaces:
• Section 3.8.1, “Configuring the Management IP Interface”
• Section 3.8.2, “Managing Switch IP Interfaces”
Section 3.8.1
Configuring the Management IP Interface
To configure the management IP interface, do the following:
1. Navigate to Administration > Configure IP Interfaces > Configure Mgmt IP Interfaces. The Mgmt IP
Interfaces table appears.
Figure 31: Mgmt IP Interfaces Table
2. Click the IP address for the management IP interface. The Mgmt IP Interfaces form appears.
53
4
1
2
Figure 32: Mgmt IP Interfaces Form
1. IP Address Type Box 2. IP Address Box 3. Subnet Box 4. Apply Button 5. Delete Button 6. Reload Button
3. Configure the following parameter(s) as required:
Parameter Description
IP Address Synopsis: ###.###.###.### where ### ranges from 0 to 255
Default: 10.0.0.1

RuggedCom RSG2488 Specifications

General

Brand	RuggedCom
Model	RSG2488
Category	Switch
Language	English