RuggedCom RSG2488 User Manual

Chapter 5
Setup and Configuration
RUGGEDCOM RSG2488
User Guide
168 Deleting an SNMP Security Model
2. Click InsertRecord. The SNMP Security to Group Maps form appears.
64
5
3
2
1
Figure 126: SNMP Security to Group Maps Form
1. Security Model Box 2. Name Box 3. Group Box 4. Apply Button 5. Delete Button 6. Reload Button
3. Configure the following parameter(s) as required:
Parameter Description
SecurityModel Synopsis: { snmpV1, snmpV2c, snmpV3 }
Default: snmpV3
The Security Model that provides the name referenced in this table.
Name Synopsis: Any 32 characters
The user name which is mapped by this entry to the specified group name.
Group Synopsis: Any 32 characters
The group name to which the security model and name belong. This name is used as an
index to the SNMPv3 VACM Access Table.
4. Click Apply.
Section 5.6.2.3
Deleting an SNMP Security Model
To delete a security-to-group map, do the following:
1. Navigate to Administration > Configure SNMP > Configure SNMP Security to Group Maps. The SNMP
Security to Group Maps table appears.
Figure 127: SNMP Security to Group Maps Table
2. Select the map from the table. The SNMP Security to Group Maps form appears.

RuggedCom RSG2488 Specifications

General

Brand	RuggedCom
Model	RSG2488
Category	Switch
Language	English