Chapter 2
Using ROS
RUGGEDCOM RSG2488
User Guide
32 Using the Command Line Interface
NOTE
Before exiting a screen, ROS will automatically prompt the user to save any changes that have
not been committed.
Ctrl + I Inserts a new record.
Ctrl + S Opens the CLI interface.
Ctrl + X Terminates the current session. This command is only available from the main menu.
Ctrl + Z Displays important information about the current screen or selected parameter.
Section 2.6
Using the Command Line Interface
The following sections describe how to use the Command Line Interface (CLI):
• Section 2.6.1, “Available CLI Commands”
• Section 2.6.2, “Tracing Events”
• Section 2.6.3, “Executing Commands Remotely via RSH”
• Section 2.6.4, “Using SQL Commands”
Section 2.6.1
Available CLI Commands
The following commands are available at the command line:
Command Description
alarms all
Displays a list of available alarms.
Optional and/or required parameters include:
• all displays all available alarms
arp Displays the IP to MAC address resolution table.
clearalarms Clears all alarms.
clearethstats [ all | port ]
Clears Ethernet statistics for one or more ports.
Optional and/or required parameters include:
• all clears statistics for all ports
• port is a comma separated list of port numbers (e.g. 1,3-5,7)
clearlogs Clears the system and crash logs.
clearstpstatus Clears all spanning tree statistics.
cls Clears the screen.
dir Prints the directory listing.
exit Terminates the session.
factory Enambles factory mode, which includes several factory-level commands used for testing
and troubleshooting. Only available to admin users.
To Next Page
Loading...
Need help?
General
