RuggedCom RSG2488 User Manual

RUGGEDCOM RSG2488
User Guide
Chapter 5
Setup and Configuration
Deleting an SNMP Group 171
Parameter Description
The minimum level of security reqwuired in order to gain the access rights allowed by
this entry. A security level of noAuthNoPriv is less than authNoPriv, which is less than
authPriv.
ReadViewName Synopsis: { noView, V1Mib, allOfMib }
Default: noView
This parameter identifies the MIB tree(s) to which this entry authorizes read access. If
the value is noView, then no read access is granted.
WriteViewName Synopsis: { noView, V1Mib, allOfMib }
Default: noView
This parameter identifies the MIB tree(s) to which this entry authorizes write access. If
the value is noView, then no write access is granted.
NotifyViewName Synopsis: { noView, V1Mib, allOfMib }
Default: noView
This parameter identifies the MIB tree(s) to which this entry authorizes access for
notifications. If the value is noView, then no access for notifications is granted.
4. Click Apply.
Section 5.6.3.3
Deleting an SNMP Group
To delete an SNMP group, do the following:
1. Navigate to Administration > Configure SNMP > Configure SNMP Access. The SNMP Access table
appears.
Figure 132: SNMP Access Table
2. Select the group from the table. The SNMP Access form appears.

RuggedCom RSG2488 Specifications

General

Brand	RuggedCom
Model	RSG2488
Category	Switch
Language	English