RuggedCom RSG2488 User Manual

RUGGEDCOM RSG2488
User Guide
Chapter 3
Device Management
Viewing a List of IP Gateways 75
IMPORTANT!
The default gateway can be configured for a switch IP interface (on the management VLAN) or the
management IP interface. When configured for a switch IP interface, the configuration will not change
when the settings are reset to the factory defaults. However, when the default gateway is configured
for the management IP interface, the settings will be reset and one of the gateways on the switch IP
interfaces will be set as the default interface.
The following sections describe how to set up and manage IP gateways:
• Section 3.9.1, “Viewing a List of IP Gateways”
• Section 3.9.2, “Adding an IP Gateway”
• Section 3.9.3, “Deleting an IP Gateway”
Section 3.9.1
Viewing a List of IP Gateways
To view a list of IP gateways configured on the device, navigate to Administration > Configure IP Gateways. The
IP Gateways table appears.
Figure 38: IP Gateways Table
If IP gateways have not been configured, add IP gateways as needed. For more information, refer to
Section 3.9.2, “Adding an IP Gateway”.
Section 3.9.2
Adding an IP Gateway
To add an IP gateway, do the following:
1. Navigate to Administration > Configure IP Gateways. The IP Gateways table appears.

RuggedCom RSG2488 Specifications

General

Brand	RuggedCom
Model	RSG2488
Category	Switch
Language	English