RUGGEDCOM RSG2488
User Guide
Chapter 4
System Administration
Configuring an Alarm 99
To clear the passive alarms from the list, do the following:
1. Navigate to Diagnostics and click Clear Latched Alarms. The Clear Latched Alarms screen appears.
Figure 65: Clear Latched Alarms Screen
1. Confirm Button
2. Press Confirm.
Section 4.4.3
Configuring an Alarm
While all alarms are pre-configured on the device, some alarms can be modified to suit the application. This
includes changing the severity and enabling/disabling certain features.
To configuring an alarm, do the following:
IMPORTANT!
Critical and Alert level alarms are not configurable and cannot be disabled.
1. Navigate to Diagnostic > Configure Alarms. The Alarms table appears.